Induction requirements
You must complete your online and in-person inductions to gain access to the laser cutter.
Minimum age requirement 16+. People under the age of 16 may use the space during specific youth programmed sessions only.
Online induction In-person programmes
How the laser cutter works
The laser cutter uses a focused carbon dioxide (CO₂) laser beam to accurately cut or engrave designs created in computer software.
- cutting involves the laser fully penetrating the material, yielding precise edges that vary in appearance depending on the material - wood typically darkens, while acrylic retains its colour and gains a glossy finish
- engraving occurs when the laser removes surface material without cutting through
- files are processed via LightBurn software installed on our computers.
Model:
Thunder Nova 24
Supported file types:
- AI (Adobe Illustrator)
- BMP
- DXF
- JPG/JPEG
- PDF
- PLT
- PNG
- SVG
- TIFF
Materials available at the library:
For your safety and to ensure the best results, only materials supplied and approved by the library may be used with the laser cutter. Outside materials are not permitted.
- acrylic
wide range of colours and finishes
charged at $1.50 per 10cm2
- leatherette
please note: incorrect laser settings can cause staining on uncut leatherette
charged at $1 per 5cm2
- plywood
0.9mm bamboo, 3mm birch, 3mm okoume, 5mm polar, 5mm okoume
charged at $0.50 per 10 cm2
- rubber
2mm and 3mm available
charged at $2 per 5cm2
Max cut size:
600 x 400mm
Back to Hawaiiki Creation Station equipment